- Control is achieved through a microprocessor-based system.
- Network technology is used to replace hard wiring (Profibus, DeviceNet or Ethernet)
- Some degree of enhanced diagnostic or protective functionality is included.
All our Motor Control Centres comply with BS EN 61439-2.
Busbar systems are rated and certified up to 690V AC as standard but are usually connected to a typical LV network of 400V
3 Phase nominal. Neutrals are normally fully rated. Specialised voltages may also be used on some plants or offshore platforms.
Busbars can be supplied up to 6300A, at 25kA/1s, 50kA/1s, 50kA/3s, 80kA/1s and 100kA/1s. All systems are Impulse tested at 8kV
VARIATIONS / ACCESSORIES
Corner Sections - inside & out
Back to Back boards
Form 1 through to Form 4, Type 1 to Type 7.
Top and bottom cable entry. (ACB's normally bottom entry but can supplied for top entry)
Front or rear cable access
All the metalwork and busbars systems for our comprehensive range of Motor Control Centres and Switchboards are manufactured for us by ROLLA Limited, a manufacturer of high quality Motor Control Centres & Distribution enclosures.