Conventional Motor Control Centres
GENERAL DESCRIPTION
Motor Control Centres (MCC's) are used to centralise the distribution of power and control to motors in the process industries.
We generally provide enclosures which are full height (over 2m) and contain an ASTA/KEMA certified Fault Rated Busbar system, are segregated to Form 4 of BS EN 61439-1.
All our Motor Control Centres comply with BS EN 61439-2.
All our Motor Control Centres comply with BS EN 61439-2.
BUSBAR SYSTEMS
Busbar systems are rated and certified up to 690V AC as standard but are usually connected to a typical LV network of 400V
3 Phase nominal. Neutrals are normally fully rated. Specialised voltages may also be used on some plants or offshore platforms.
Busbars can be supplied up to 6300A, at 25kA/1s, 50kA/1s, 50kA/3s, 80kA/1s and 100kA/1s. All systems are Impulse tested at 8kV
Busbars can be supplied up to 6300A, at 25kA/1s, 50kA/1s, 50kA/3s, 80kA/1s and 100kA/1s. All systems are Impulse tested at 8kV
VARIATIONS / ACCESSORIES
Busbar Bridges
Corner Sections - inside & out
Transformer Housings
Back to Back boards
Busduct connections
Corner Sections - inside & out
Transformer Housings
Back to Back boards
Busduct connections
FORM/ACCESS
Form 1 through to Form 4, Type 1 to Type 7.
Top and bottom cable entry. (ACB's normally bottom entry but can supplied for top entry)
Front or rear cable access
Front or rear cable access
PARTNERS
All the metalwork and busbars systems for our comprehensive range of Motor Control Centres and Switchboards are manufactured for us by
ROLLA Limited, a manufacturer of high quality Motor Control Centres & Distribution enclosures.